AMX UPC20+

UPC20+

Overview
Designed for conduit installation the Universal Power/Motor Controller 20 A (110/220 VAC input) is a dual 20-amp AC power and motor controller. Configure a wide range of power and motor control modes for a full range of devices ranging from simple wall panels with low voltage contact closure to large systems requiring high voltage contact closure.

The UPC20+ supports two primary operating modes. In Motor Control Mode the two relays are automatically activated in sequence with an adjustable delay from 0 to 90 seconds. In this mode there are three control options:

• Single Button Mode operates with one pushbutton in a sequence: Up Stop Down Stop and so on for each successive button press.

• Two / Three Button Mode operates with two pushbuttons one for Up and one for Down and optionally one for stop.

• Momentary On/Off operates the first relay only while the button is pressed and then second the relay activates when the button is released.

In Power Control mode the UPC20+ provides power control for two independent circuits with a combined total load of 20 Amps. In this mode there are three control options:

• Momentary Power Mode operates the selected relay only while the button is pressed. The relay is de-activated when the button is released.

• Latching Power Mode toggles between activating and deactivating the selected relay on each successive button press.

• Two Button On/Off Mode uses two buttons for each relay one to activate and one to deactivate.

Features
• 1 2 and 3-button logic modes
• Local test switches with status LEDs
• 120 240 and 277 VAC control capability
• ETL listed